Well, I need this for a "race" with a wheelbarrow.
When I place the IR sensor in about 15cm height, then with this wheelbarrow and the person behind it pass the IR sensor "several times"...
This is why I wanted to extend this time to make sure there is no wrong measuremt or start and stop when not wanted.
1or2 seconds should be fine...
I hope this makes it clearer....
Can you define exaclty in which sequence I have to set up the ini file so that I can modify this time and how the program will take it?
In another post I was asking for this sequence, but it is still unclear to me:
When I change the External setting to my wishes and then close the whole program, then change the ini file and then start the program again: Will the external settings then still be correct?
Cause when I open it it is back to none....
Thanks for your patience with my
and for your support and help!
BR Ingo
Well, I need this for a "race" with a wheelbarrow.
When I place the IR sensor in about 15cm height, then with this wheelbarrow and the person behind it pass the IR sensor "several times"...
This is why I wanted to extend this time to make sure there is no wrong measuremt or start and stop when not wanted.
1or2 seconds should be fine...
I hope this makes it clearer....
Can you define exaclty in which sequence I have to set up the ini file so that I can modify this time and how the program will take it?
In another post I was asking for this sequence, but it is still unclear to me:
When I change the External setting to my wishes and then close the whole program, then change the ini file and then start the program again: Will the external settings then still be correct?
Cause when I open it it is back to none....
Thanks for your patience with my :-)
and for your support and help!
BR Ingo